Search

How To Assemble Star Trek Discovery Type 2 Phaser

Step 1


Take the Handle part of the model and the tail of the phaser and glue them like shown above using epoxy or hot glue. Leave for glue to set.


Step 2


Next take the nose part and attach it to the front of the phaser like shown above using epoxy or hot glue. Leave the glue to set.


Step 3


Now take the cylindrical optic barrel and glue it onto the front of the phaser like shown above. Use epoxy or hot glue. Leave for glue to set.


Step 4


You dont need any glue for this step. Mini Phaser display attaching. Take the display part and puch it into the place like shown above. you may need to use a little force to push it in place until it snaps in place and swivels at the front axis. Watch the GIF above multiple times before attempting. Angle the display like seen in the GIF and push it until it is level and flush with the body of the mini phaser. You may need to wear it out by lifting and closing the display to get smooth open and close movement.


Step 5


Finally you can push the mini phaser into the main body like shown above it will snap in place witha satisfying sound and it will sit there tightly. If you wish to remove it push with your finger to the bottom like shown above to make it come lose. Your Type 2 Phaser is now complete.

Hope you like it.

9 views